Should you use a sealer for blown head gasket

A head gasket sealer has the capability to seal the blown head gaskets and also the small cracks found in the cylinder head. Although, a lot of people would rather want to have their head gasket changed than try using a head gasket sealer, but, as the expenses for vehicle repair is increasing, there is already greater demand for a product such as this one. Bear in mind that the average cost of head gasket replacement is approximately four hundred British pounds whereas when you make use of a sealer to fix the problem, you will only get to spend about thirty British pounds.

An example of a head gasket sealer is known as the Steel Seal. This is a combination of an antifreeze component and water which is poured into the radiator of the vehicle’s engine. When an engine will begin functioning and will eventually reach its operating temperature, this product will then be distributed all-through the engine. This will be drawn to the area of damage and will seal the crack through an action process is called a thermo-chemical bonding. This kind of head gasket sealer is equivalent to the epoxy but this in the form of liquid. You can learn more and find more reviews at http://www.mylabguide.com/best-head-gasket-sealers/

During the application of this kind of head gasket sealer, it is important that the engine of the vehicle is cold while turning the heater on to maximum but do not try to use the fan. Mix ahead of time one liter of water and one liter of antifreeze with the suggested amount of the head gasket sealer. Before you start the engine, pour the mixed solution which have been combined earlier inside the radiator and if it is not yet sufficient, pour an additional mixture only in half of the amount as the previous mixture. Then, return the radiator cap on.

Attempt to start the engine while holding its revolution to approximately one thousand RPM. Make sure that the temperature will reach two hundred ten degrees Fahrenheit or ninety nine degrees Celsius since this is the standard operating temperature for the engine to function and then cool the engine for about sixty minutes. Once cooled, perform the process all over twice within the day so you will know if the head gasket sealer has functioned well. Subsequently, even if you will have doubts in using this kind of head gasket sealer, just remember that a lot of people have already tried this one and have saved a small fortune instead of replacing the head gasket.

Leave a Reply

Your email address will not be published. Required fields are marked *